setstats
 
Search:
Sort By Date
 
 

ZXLD1352

Diodes Inc.


Product Web Page
Report Broken Link

Product Description:
The ZXLD1352 is a continuous mode inductive step-down converter, designed for driving single or multiple series connected LEDs efficiently from a voltage source higher than the LED voltage. The device operates from an input supply between 7V and 30V and provides an externally adjustable output current of up to 350mA. Depending upon supply voltage and external components, this can provide up to 8 watts of output power. The ZXLD1352 includes the output switch and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current. Output current can be adjusted above, or below the set value, by applying an external control signal to the 'ADJ' pin. The ADJ pin will accept either a DC voltage or a PWM waveform. DC voltages between 0.3V and 2.5V allow adjustment of output current from 25% to 200% of nominal. 1000:1 adjustment of output current is possible using PWM control. Applying a voltage of 0.2V or lower to the ADJ pin turns the output off and switches the device into a low current standby state. The device is assembled in a TSOT23-5 pin package.


Product Specifications:
Features
Simple low parts count
Internal 30V NDMOS switch
350mA output current
Single pin on/off and brightness control using DC voltage or PWM
1000:1 PWM dimming range
Soft-start
High efficiency (up to 95%(*))
Wide input voltage range: 7V to 30V
40V transient capability
Output shutdown
Up to 1MHz switching frequency
Inherent open-circuit LED protection
Typical 4% output current accuracy

Product Overview Specs
Part Number ZXLD1352
Min.- Max. Input Voltage (V) 7 ~ 30
Output Voltage (V) 30
Typ Peak Output Current (A) 0.35
Max Output Current (mA) -
LED Current Accuracy (%) 5
Frequency (kHz) typ 1000
Efficiency (%) 97
Operating Temperature (C) -40 to +105
Quiescent Current (mA) typ -
Standby Quiescent Current (uA) typ 20



Post Your Comment